QQuestionOther Subjects
QuestionOther Subjects
Place the steps for jumping a car battery in the correct order:
Park a functioning car as close as possible to the dead car without the two cars touching.
Clamp the red cable to the red/positive terminal of the dead car.
Attach the other red cable to the red/positive terminal of the live car.
Attach the black cable to the black/negative terminal of the live car.
Attach the last black/negative cable to an unpainted piece of metal (not aluminum) on the dead car.
Turn the live car on and push the gas very lightly, giving juice over to the dead battery.
Once the receiving car has started, remove cables in the opposite order they were placed.
12 months agoReport content
Answer
Full Solution Locked
Sign in to view the complete step-by-step solution and unlock all study resources.
Step 1:Here's the correct order for jumping a car battery, with each step carefully explained:
Step 2:: Position the Cars
- Park a functioning car as close as possible to the dead car without the two cars touching - Ensure both cars are in park/neutral with parking brakes engaged - Turn off both vehicles completely
Step 3:: Prepare Jumper Cables
- Identify the red (positive +) and black (negative -) terminals on both batteries - Ensure jumper cables are in good condition with no exposed wire
Step 4:: Connect Red Cable to Dead Battery's Positive Terminal
- Clamp the red cable to the red/positive terminal of the dead car's battery - Ensure a secure, tight connection
Step 5:: Connect Red Cable to Live Battery's Positive Terminal
- Attach the other end of the red cable to the red/positive terminal of the live car's battery - Confirm connection is tight and secure
Step 6:: Connect Black Cable to Live Battery's Negative Terminal
- Attach the black cable to the black/negative terminal of the live car's battery
Step 7:: Ground the Negative Cable
- Attach the last black/negative cable to an unpainted piece of metal (not aluminum) on the dead car's engine block - This provides a safe ground for the electrical connection
Step 8:: Start the Live Car
- Turn on the live car and push the gas very lightly - Allow the live car to provide electrical charge to the dead battery
Step 9:: Start the Dead Car
- Try to start the car with the dead battery - If it doesn't start immediately, wait a few minutes and try again
Step 10:: Remove Cables
- Once the receiving car has started, remove cables in the REVERSE order they were placed - Disconnect from unpainted metal, then negative terminal, then positive terminals
Final Answer
Follow these steps carefully to safely jump-start a car battery, ensuring proper cable connection order and grounding.
Need Help with Homework?
Stuck on a difficult problem? We've got you covered:
- Post your question or upload an image
- Get instant step-by-step solutions
- Learn from our AI and community of students